Sempatap Adhesive
Out of stock
Only %1 left
SKU
Sempatap Adhesive
SEMPATAP ADHESIVE Use for installing SEMPATAP 5mm THERMAL AND SEMPAFLOOR. read more
Enquire about this product
Fast delivery available
Tested & verified products
Over 50 years experience
Need some advice? Please call us on 01372 743 334
We’re open 9:00am - 5:00pm Mon-Fri
SEMPATAP ADHESIVE Use for installing, SEMPATAP 5mm, SEMPATAP THERMAL AND SEMPAFLOOR.
PREPARATION - Surfaces must be sound, smooth, dry and free from contaminants. Very porous surfaces should be primed with one coat of SEMPATAP A PRIMER.
APPLICATION – Stir well before use. Apply one liberal coat of SEMPATAP ADHESIVE by brush, roller or notched trowel. Apply the SEMPATAP ADHESIVE to one metre wide of wall, ceiling or floor surface extending application 10 cms only.
Fix SEMPATAP 5mm, SEMPATAP THERMAL and SEMPAFLOOR in place in accordance with application instructions. Smooth out, removing all air pockets, using SEMPATAP SPATULA.
Apply SEMPATAP ADHESIVE to the next one metre area and fix SEMPATAP/SEMPAFLOOR in place, continuing this method until entire area has been covered.
COVERAGE – Approximately 2.5 litres for each 5²m, depending on condition and absorbency of the surface.
WORKING TIME – Up to 60 minutes, depending on temperature, humidity and absorbency of the surface.
STORAGE – unopened containers should be stored in dry, well ventilated conditions between 5°C and 30°C. Protect from frost.
CLEANING – Brushes, rollers and trowels must be cleaned after use with water whilst the adhesive is still wet.
PRECAUTIONS – Do not apply loads or move furniture on the floor until the adhesive has fully set.
HEALTH & SAFETY ADVICE
Avoid prolonged contact with skin, use barrier cream or gloves for the hands. In case of contact with eyes, mouth or nose, wash with water and obtain medical attention. If spilled, remove and dispose of in accordance with national and local regulations for waste materials.
SEMPATAP ADHESIVE APPLICATION INSTRUCTIONS
Stir well before use. Apply one liberal coat of SEMPATAP ADHESIVE by brush, roller or notched trowel eg. Apply the SEMPATAP ADHESIVE to one metre wide of wall, ceiling or floor surface extending application 10 cms only.
Fix SEMPATAP 5mm, SEMPATAP THERMAL and SEMPAFLOOR in place in accordance with application instructions. Smooth out, removing all air pockets, using SEMPATAP SPATULA. Apply SEMPATAP ADHESIVE to the next one metre area and fix SEMPATAP THERMAL/SEMPAFLOOR in place, continuing this method until entire area has been covered.
COVERAGE – Approximately 2.5 litres for each 5²m, depending on condition and absorbency of the surface.
WORKING TIME – Up to 60 minutes, depending on temperature, humidity and absorbency of the surface.
STORAGE – unopened containers should be stored in dry, well ventilated conditions between 5°C and 30°C. Protect from frost.
CLEANING – Brushes, rollers and trowels must be cleaned after use with water whilst the adhesive is still wet.
PRECAUTIONS – Do not apply loads or move furniture on the floor until the adhesive has fully set.
HEALTH & SAFETY ADVICE
Obtain the relevant Material Safety Data Sheets and follow the advice given.
Ensure adequate fresh air ventilation during and after use.
Avoid prolonged contact with skin, use barrier cream or gloves for the hands. In case of contact with eyes, mouth or nose, wash with water and obtain medical attention. If spilled, remove and dispose of in accordance with national and local regulations for waste materials.